Open page 23 in the flipbook · All pages
S H E E T S H E E T P R O D U CT S Why UHMW-PE Outwears steel where things slide. In sand-slurry abrasion testing, UHMW- PE loses about one-sixth the material that carbon steel does — at one- eighth the weight. Abrasion wear vs. steel Sand-slurry test, relative volume loss. Carbon steel = 100. Lower is better. ~6× less abrasion wear than carbon steel 0.10– 0.20 friction on steel, dry (steel on steel 0.25– 0.35) ⅛ the weight of steel (0.94 vs 7.85 g/cm³) Source: published manufacturer sand-slurry data (24 h, 1,750 rpm, 50/50 sand/water), virgin UHMW-PE. Typical values; results vary with grade, load, speed and temperature. UHMW-PE is not a structural replacement for steel — it is used as a wear and slide surface over a steel or wood frame. Performance at a glance High slip Material slides instead of sticking, bridging or hanging up Impact tough Takes hits without cracking, even in the cold Wear resistant Stands up to sliding abrasion from sand, gravel and grain Chemical resistant Shrugs off most acids, alkalis, salts and fertilizers Moisture proof Won’t absorb water, rot, rust or swell Lightweight About one-eighth the weight of steel, easy to handle and install Chemical resistance AT ROOM TEMPERATURE RATING Acids (most, incl. hydrochloric & sulfuric) Resistant Alkalis & caustics Resistant Salts & fertilizers Resistant Water, steam & detergents Resistant Alcohols & many solvents (room temp.) Resistant Strong oxidizers (e.g. fuming acids) Not recommended Hot aromatic or chlorinated solvents Not recommended General guide only. Confirm suitability for your specific chemical, concentration and temperature. UHMW-PE 15 Nylon 6/6 31 Stainless steel (304) 84 Carbon steel 100 Polypropylene 190 Yellow brass 400 Quotes · samples · custom sizes 1-800-661-8024 · [email protected] · fpbags.com Friesen Plastics Inc. · Flexible Packaging 23
Friesen Plastics Inc. · 1-800-661-8024 · [email protected] · fpbags.com